Allocation begins at the start from W0000, with 1 register used for each 2-byte address. Byte addresses 0000-0011 are for the link relay (from B0000 onwards), and byte addresses from 0012 onwards are for the link register.(The range can also be changed as desired by clicking "Edit".) (B)/link register (W) allocated to the registered CV-X100 Series controller. Checkthe range (hexadecimal)of the linkrelay.(In the notation, output from CV-X100 is treated as "IN (input)".) (+) next to "Class1" for the registered CV-X100 to check the allocation status of the device. Open "EtherNet/IP settings" from the "Setup unit (2)" tab in KV STUDIO Unit Editor, and click the plus sign The EtherNet/IP output settings are set so that the result data shown below is output.Ģ Check the relationship between the byte address and the link register (W) in KV STUDIO. Checking the format for output to the byte address, and the relationship between the byte address and the link register (W)ġ Check an example of result data stored to the byte address. (In the example above, it is byte address 048.)Ģ. The byte address starting position is the position allocated to "Result Data1" on the "Data Configurations" - "Send-Data" - "View List" screen.
KEYENCE PROGRAMMING SOFTWARE SOFTWARE
Therefore, contacted many friends to find this software to share with you Unlike KV-Builder integrated in KV-Studio, Ladder Builder version supports programming all Keyence KZ PLCs.
KEYENCE PROGRAMMING SOFTWARE HOW TO
This section explains how to allocate the measured/judged values below as an example. Use the output settings to output the measured values and judged values. Setting the output data (Output Settings)