Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide 3-10 OL-18362-01.If the interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices.If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures.
Audience This guide is for network administrators who perform any of the following tasks: Managing network security. This section includes the following warnings: Power Supply Disconnection Warning, page vii. Warning Statement 1001 Installation Instructions Warning Read the installation instructions before connecting the system to the power source. Statement 1004 Warning Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide OL-18362-01. Ensure that Warning a fuse or circuit breaker no larger than 120 VAC, 15A U.S. VAC, 10A international) is used on the phase conductors (all current-carrying conductors). Statement 13 Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide OL-18362-01. They can also be used as regular Ethernet switch ports, just like the ports numbered 0 through 5. Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide OL-18362-01. For more information, see the Cisco Security Appliance Command Line Configuration Guide. Cisco Asa 5505 Software Version 8Memory Requirements for the Software Version 8.3 and Later For information on memory requirements for the adaptive security appliance for software Version 8.3 or. The adaptive security appliance models equipped with AC-input power supplies are shipped with a. Configuring Equipment Racks For information on physical specifications, see table 7 at the following url: ecd802930c5.html. Check the LINK LED to verify that the network devices have basic connectivity to the Cisco ASA 5505 Step 3 on one of the inside ports (numbered 0 through 7). Cisco Asa 5505 Serial Terminal EmulatorTo connect to the console port and run a serial terminal emulator on a PC or workstation, perform the following steps: Plug one end of the PC terminal adapter into a standard 9-pin PC serial port on your PC. Attach the cable lock to the lock slot on the back panel of the Cisco ASA 5505. Step 4 Step 5 Screw the four screws provided in the accessory kit into the anchors, but not all the way. Allow them to protrude about 18-inch (0.317 cm). Use the three screws provided in the Step 2 accessory kit to screw the wall-mount bracket to the adaptive security appliance as shown in Figure 3-13.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |